Filter Results
Type
For Tube Size
Thread Size
Connection Type
Pipe Size
Max Op Pressure
Specs Met
Brass 45° Flare Tube Fittings

Brass 45° Flare Tube Fittings

Create a tight seal on flared metal tubing with these corrosion-resistant brass flare fittings, which are suitable for use with non-potable (not for human consumption) water. 45° flare fittings are commonly used in refrigeration systems, air compressors, and machinery and can tolerate lower pressures than 37° flare fittings.

Flare fittings have a body, nut, and sleeve (ferrule). The nut and sleeve are inserted onto the tubing, the end of the tubing is flared, and the nut is tightened onto the fitting to secure it in place. Suitable for high pressures, they resist pulling out if there is vibration in the line and can be installed and removed repeatedly.

Unions

Join tubing running in the same direction with these fittings.

Connectors

Use these fittings to connect female-threaded pipe to tubing in a straight line.

Male Flare x Female NPT

Male Flare x Male NPT

Reducers

Connect tubing to male-threaded pipe with these reducers.

Tube End Adapters

Make different types of tubing connections with these adapters. They have a flare fitting connection on one end and a push-to-connect connection on the other end.

45° Elbows

Redirect tubing at a 45° angle with these elbows, which have a threaded connection on one end and a tubing connection on the other. They restrict flow less than 90° elbows to minimize pressure loss.

Male x Male Elbow

Male x Male Extruded Elbow

90° Elbows

Make a sharp 90° change in the direction of your tubing with these 90° elbows. They have a threaded connection on one end and a tubing connection on the other.

Male Flared x Male Flared

Male Flared x Male NPT

Male Flared x Female NPT

Male Flared x Female NPS

Union Tees

Merge two lines or split a single line into two with these union tee fittings. They have tubing connections on all ports.

Run Tees

Create a 90° branch to send flow into two tubing lines or to join flow from two tubing lines. Run tees have a tubing connection in the middle set at a 90° angle to a threaded connection on one end and a tubing connection on the other.

Branch Tees

Combine two lines into one or split a single line into two with these tees. They have a threaded middle port set at a 90° angle to a tubing connection on either end.

Caps

Stop or direct the flow of material in your tubing system and protect external threads on fitting heads using these caps.

Plugs

Insert these plugs into fittings or tube ends to close them off and seal out dirt and contaminants.

Nuts

Secure fittings to tubing with these nuts.

Long Forged Nut

Long Nut

Short Forged Nut

Short Nut

Seal Bonnets

Place seal bonnets over flare fittings on capped lines to prevent leaks.

Copper Flare Gaskets

Use these gaskets to prevent leaks from worn out flares.