These fittings are made from corrosion-resistant brass and come preassembled with a captive sleeve (or ferrule) that is correctly positioned in the nut for quick installation. The acetal copolymer sleeve resists creeping and compression stress and holds tubing in place even when the maximum pressure for the tubing is exceeded.
Compression fittings do not require welding, flaring, or any other tube preparation to install, reducing installation time and maintenance costs. The sleeve compresses against the tubing as the nut is tightened to form a tight seal. For use with hard plastic or metal tubing.
Join tubing running in the same direction with these fittings.
Use these fittings to connect threaded pipe or fittings to tubing in a straight line.
Make a sharp 90° change in the direction of your tubing with these 90° elbows. They have a threaded connection on one end and a tubing connection on the other.
Male NPT Pipe Connection
Merge two lines or split a single line into two with these union tee fittings. They have tubing connections on all ports.
Create a 90° branch to send flow into two tubing lines or to join flow from two tubing lines. Run tees have a tubing connection in the middle set at a 90° angle to a threaded connection on one end and a tubing connection on the other.
Combine two lines into one or split a single line into two with these tees. They have a threaded middle port set at a 90° angle to a tubing connection on either end.
Find replacement sleeves for keeping fitting nuts in place.
Nut & Sleeve Sets
Attach fittings to tubing with these sets, which contain a nut and a sleeve.
Use ferrules to get a tight seal when installing a fitting onto a length of tubing.