Filter Results
Accessory Type
Material
Air Cylinder Mounting Hardware

Air Cylinder Mounting Hardware

Mount air cylinders to align, secure, and provide greater rigidity in your system. Hardware includes brackets, plates, and bands.

Rod Clevis, Rear Clevis, Double Clevis, & Clevis Kits

Connect a cylinder to the end of a piston with these U-shaped fasteners. They allow the cylinder to pivot and provide minor swivel movement.

Rear Clevis Mount

Aluminum

Rod Clevis

Aluminum

Carbon Plated Steel

Plated Steel

Stainless Steel

Steel

Eye Brackets

Use these brackets to provide a rear pivot mounting for tie-rod cylinders or use them in conjunction with a clevis bracket. They help prevent side loading that can cause wear and premature failure of cylinders.

Eye Bracket

Aluminum

Stainless Steel

Rod Clevis

Aluminum

Wall Mount Eye Bracket

Aluminum

Clevis Brackets

Allow your cylinders to pivot freely during a work cycle by using clevis brackets. Insert the included clevis pin through the bracket holes to mount rods to a flat surface.

Clevis Bracket

Aluminum

Clevis Bracket GA

Aluminum

Clevis Bracket MP4

Aluminum

Wall Mount Clevis Bracket

Aluminum

Pivot Brackets

Typically used when you want to weld rather than bolt the brackets into place, these two-piece brackets hold your cylinders so they can pivot freely during their work cycle.

Pivot Bracket

Aluminum

Rear Pivot Bracket

Plated Steel

Stainless Steel

Rod Clevis

Aluminum

Foot Brackets

Keep cylinders stationary during work cycles by mounting foot brackets underneath them. They provide a fixed mount to prevent the cylinder from pivoting back and forth.

Foot Bracket

Aluminum

Anodized Aluminum

Plated Steel

Stainless Steel

Side Lug Mounts

Provide a rigid mount for cylinders with these side lug mounts when moving loads along flat guided surfaces such as carriage rails.

Side Lug Mount

Aluminum

Front & Rear Flange Mounts

For applications that require an extra rigid installation, these thick, wide-head mounts securely hold the flat ends of an air cylinder.

Steel

Flange Plate

Plated Steel

Front Flange Mount

Aluminum

Rear Flange Mount

Aluminum

Rectangular Flange Bracket

Aluminum

Rod Eyes

Thread these rod eyes onto the end of a cylinder shaft to provide a pivoting eyehole. They are commonly used in tandem with clevis brackets.

Rod Eye

Aluminum

Single & Rear Clevis Mounts

Mount these clevis brackets to the rear of the air cylinder to allow it to pivot during the work cycle.

Double Rear Clevis

Plated Steel

Rear Detachable Clevis

Aluminum

Single Rear Clevis

Anodized Aluminum

Plated Steel

Center-Mount & Foot-Mount Brackets

Distribute force evenly across the cylinder by using these mounts to fasten and center the cylinder.

Center Mount

Foot Mount

Couplers, Jam Nuts, & Mounting Nuts

Lock your brackets in place with these couplers and nuts.

Cylinder Mounting Nut

Aluminum

Jam Nut

Plated Steel

Nose Thread Nut

Plated Steel

Auto-Switch Mounts

Hold cylinder position sensors in place with these auto-switch mounts. They can be adjusted by tightening or loosening the attached screw.

Autoswitch Band

Plated Steel

Autoswitch Clip

Composite

Switch Mount