Filter Results
Input Voltage
Load Capacity
Stroke Length
Limit Switch
Industrial-Duty Rod-Style Electric Actuators

Industrial-Duty Rod-Style Electric Actuators

Rely on these industrial electric actuators to handle high duty cycles and speeds. Use clevis pins for mounting. These are rod-style actuators with external rods that deliver thrust to push or pull loads. They're often used in place of hydraulic or air cylinders because they allow more precise positioning, run more quietly, and don't contain potentially hazardous fluids, but they're not suited for hazardous environments or continuous operation applications.

The duty cycle rating is the amount of time per operating cycle at the rated load that the actuator spends extending and retracting ("on" time) versus the time it rests ("off" time). Typically expressed as a percentage of "on" time, a duty cycle of 33% for a 60 second cycle would spend 20 seconds on and 40 seconds off.

Belt Driven with Horizontal Motor

Belt Driven with Horizontal Motor

These belt-driven actuators can be mounted horizontally. They typically perform better in harsh environments than gear-driven actuators since water and non-caustic liquids will not impede the belt's performance. The belt does not need to be lubricated.

12V DC Input Voltage

100 lb

250 lb

Gear Driven with Vertical Motor

Gear Driven with Vertical Motor

Choose these gear-driven actuators for applications where actuators need to be mounted vertically. Since they don't use belts, which can stretch over time, they provide more accurate positioning than belt-driven actuators. The gears require lubrication.

12V DC Input Voltage

500 lb

115V AC Input Voltage

500 lb

Gear Driven with Horizontal Motor

Gear Driven with Horizontal Motor

Mount these gear-driven actuators horizontally. Since they don't use belts, which can stretch over time, gear-driven actuators provide more accurate positioning than belt-driven actuators. The gears require lubrication.

115V AC Input Voltage

1,500 lb