Filter Results
Measurement System
Bore Size
OD
Overall Width
Material
Finish/Coating
Two-Piece Clamp-On Shaft Collars

Two-Piece Clamp-On Shaft Collars

You can install or remove these two-piece clamp-on shaft collars, also known as double-split shaft collars, without removing other parts on the shaft, which helps reduce downtime in maintenance and repair tasks. They can be installed anywhere on the shaft and don't require you to disassemble the machine if you don't have access to the ends of the shaft. Set screws are not required to hold the clamp in place, making these shaft collars less likely to damage the shaft than set-screw shaft collars. The clamp-on design evenly distributes the gripping force around the shaft for a more secure hold than set-screw collars and makes it easier to fine-tune the shaft collar's position.

General Purpose Steel

Steel shaft collars provide good strength and hardness and are the most common choice for a wide range of applications where corrosion is not a concern.

Inch

Black Oxide Coated Steel

Metric

Black Oxide Coated Steel

Corrosion-Resistant Stainless Steel

Made from corrosion-resistant stainless steel, these shaft collars are suitable for use in applications where corrosive elements may be present, such as food processing, pharmaceutical, and marine facilities.

Inch

303 Stainless Steel

316 Stainless Steel

Metric

303 Stainless Steel

Washdown Acetal

Ideal for applications where equipment will be washed down frequently, such as food-and-beverage processing equipment, acetal shaft collars will not rust or corrode when exposed to water. They are nonmagnetic.

Inch

Acetal

Lightweight Aluminum

Nonmagnetic lightweight aluminum shaft collars provide good corrosion resistance and help keep inertia low in applications where the rotational speed of the drive system will vary.

Inch

Uncoated Aluminum

Metric

Uncoated Aluminum

Black Anodized Aluminum

Metric OD with Inch Bores

These collars have metric outer dimensions and inch-sized bores for use on metric equipment with inch-sized shafts.

Inch

Uncoated — 316 Stainless Steel

With Recessed Screw

The clamping screws on these shaft collars are fully recessed so that the outer surface of the collar does not have any projections that could potentially damage equipment.

Inch

Black Oxide Coated Steel