View Similar Products

Parker Hannifin Air Brake Compression 90° Tube Elbow: Nylon, 5/8 in Port 1 Tube Size, 3/4 Pipe Size (Port 2), Male, NPT

Item # 390R532

$25.15 Each

Product Specs

Type: Elbow
For Tubing Material: Nylon
Port 2 Gender: Male
Material: Brass
Port 1 Tube Size: 5⁄8 in
Maximum Operating Temperature: 200 ° F
Minimum Operating Temperature: -40 ° F
Pack Qty: 1
Tube Size: 5⁄8 in
Port Type: NPT
Pipe Size: 3/4
Specifications Met: SAE J246; SAE J1131; DOT FMVSS 571.106
Application: Air Ride; Air Brakes; Air Tanks; Sliders; Tire Inflation; Primary and Secondary Air Lines; Cab Controls
Connection Thread Size: 13/16"-18
Elbow Angle: 90 °
Features: Ribbed Sleeve for Compression and Positive Grip; For Use in Air Brake Systems on Semi-Trucks, Trailers, Buses, Mobile Equipment and Farm Implements; Pre-Applied Thread Sealant
For Substance Type: Bio-Diesel
For Tube OD: 5⁄8 in
Maximum Operating Pressure: 150 psi
Pack Unit: EA
Pipe Size (Port 2): 3/4
Port 1 Connection Type: Compression
Port 1 Gender: Female
Port 2 Connection Type: NPT
Port 2 Thread Size: 13/16"-18
REACH Compliant: Yes
RoHS Compliant: Yes
Sleeve Material: Brass
Thread Standard: NPT

Compliance and Restrictions

This product contains a chemical that is regulated under California Proposition 65.
  • Warning: This product contains a chemical known to the State of California to cause birth defects or other reproductive harm.
  • Warning: This product contains a chemical known to the State of California to cause cancer.

Country Of Origin

  • USA

About This Product

This Air Brake Compression 90° Tube Elbow from Parker Hannifin is used with nylon tubing and has a 5/8 in port 1 tube size. It has a 3/4 pipe size on port 2 and a male connection on port 2. It also has a NPT port 2 connection type and a 150 psi maximum operating pressure. Sold individually.

About Air Brake Compression Tube Fittings

Use these fittings to connect air brake lines on semis, trailers, buses, and farm equipment. They meet DOT FMVSS 571 and SAE J246 requirements for air brake lines.

Compression fittings do not require welding, flaring, or any other tube preparation to install, reducing installation time and maintenance costs. They consist of a body, nut, and sleeve (or ferrule). The sleeve compresses against the tubing as the nut is tightened to form a tight seal. For use with hard plastic or metal tubing.

Make a sharp 90° change in the direction of your tubing with these 90° elbows. They have a threaded connection on one end and a tubing connection on the other.

Associated Products (1)