View Similar Products

Submersible Deep Well Pump: 1/2 hp Input Horsepower, Thermoplastic, 115V AC, 11 gpm Max Flow Rate, 265 ft Max Head, 9 Stages, 12 A, 3 3/4 in Pump Ht

Item # 979R034

$646.84 Each

Product Specs

Phase: 1
Voltage: 115V AC
Input Horsepower: 1⁄2 hp
Maximum Flow Rate: 11 gpm
Maximum Head: 265 ft
Number of Stages: 9
Current: 12 A
Pump Height: 3 3⁄4 in
Pump Depth: 29 7⁄8 in
Discharge Head Material: Thermoplastic
Application: Home; Farm; Ranch; Commercial; Industrial
Bearing: Rubber; Ceramic
Control Box Included: No
Control Box Required: Yes
Diffuser Material: Stainless Steel
Features: It Has Built-in Check Valve; Water Lubricated; Install Vertically or Horizontally; It Deliver a More Consistent Volume of Water Over the Range of Pressure Switch Settings Than a Jet Pump
For Fluid Type: Water
Impeller Material: Noryl
Intake Screen Material: Polyethylene
Maximum Flow Rate @ Various Head: 8 gpm @ 100 ft of Head; 3 gpm @ 200 ft of Head; 9 gpm @ 20 ft of Head; 7 gpm @ 100 ft of Head; 11 gpm @ 20 ft of Head
Maximum Fluid Temperature: 120 ° F
Maximum Head Pressure: 50 psi
Maximum Operating Temperature: 86 ° F
Motor Type: Franklin
Number of Wires: 3
Power Source: Electric-Powered
Pump Width: 3 3⁄4 in
Resistance Properties: Thermal-Resistant; Corrosion-Resistant; Sand-Resistant
Runs Dry: Yes
Shaft Material: 303 Stainless Steel
Specifications Met: NEMA
Submersible: Yes

Compliance and Restrictions

Country Of Origin

  • Mexico
This item has been restricted from sale in the following states.
  • CA, MD and VT.

About Well Pumps & Well Pump Heads

Deliver potable water from wells to residential or farm storage tanks that feed plumbing systems by using well pumps. These submersible pumps sit at depths where water tables are found to draw in water and push it up to supply tanks. Water pressure helps move water into these pumps, making them more energy efficient than jet pumps. They're typically used for residential water supplies and irrigation applications.

Get convenient, surface-level access to motor starting components and a capacitor-driven starter for reliable operation with 3-wire pumps. Their above-ground panel controls the pump motor, so you can service or replace starting components such as capacitors and relays without removing the pump from the well. These pumps typically run more smoothly, generate less heat, and draw less current over time than 2-wire models. They can also be used in water with heavy-scale or abrasives since their motor generates higher starting torque than 2-wire pumps to help loosen mineral deposits from the pump's moving parts.